Truck will run for a bit but after a couple of miles it will stall and not start up again for an hr.

1972 CHEVROLET CHEYENNE
Avatar
ACHRON415
  • MEMBER
  • 4 POSTS
I have replaced the dist. rotor, ignition mod., spark plugs and wires, alternator, fuel pump and fuel filter.
Apr 12, 2012 at 12:22 AM
Advertisement
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
this truck had points from the factory. What motor??
Roy
Apr 12, 2012 at 12:24 AM
Avatar
ACHRON415
  • MEMBER
  • 4 POSTS
truck has a 350 that is rebuilt and no. uses ignition coil with I replaced already about three days ago.
Apr 12, 2012 at 3:04 AM
Avatar
ASEMASTER6371
  • CAR REPAIR CONTRIBUTOR
  • 52,796 POSTS
check the module and the pick up in the distributor.

Roy
Apr 12, 2012 at 11:56 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.