CAR IDLES AND STALLS AFTER NEW INTAKE

  • Tiny
  • LegacySub
  • Subaru

Hi,
I have a 92 Subaru Legacy sedan. It is a 4 cyl, 2.2 liter engine. It has 144,000 miles on it and is 4WD. I recently just put on an intake tube that I bought, I also bought a mass air flow mount, so that my old mass air flow sensor can adapt to my new tube. After putting it on though, the car would only start and then die. As long as I was giving it gas the car would run fine, but if I came to a stop or put it in any other gear other than drive I would die. It will start again fine though, I put my old air intake tube and housing back on and it now runs fine. But I want to use my Air Intake that I bought, any ideas on this?

Do you
have the same problem?
Yes
No
Monday, September 10th, 2007 AT 5:23 PM

0 Replies

Please login or register to post a reply.

Similar Questions