1998 Plymouth Breeze no start with CAM sensor connected

Tiny
STORMRIDER57
  • MEMBER
  • 1998 PLYMOUTH BREEZE
  • 4 CYL
  • FWD
  • AUTOMATIC
  • 135,750 MILES
Thanx for any help you can give. '98 breeze with 2.4, will not start with cam sensor connected, I understand the pcm goes into limp mode. Replaced cam sensor, replaced pcm, also found pour resistance on signal wire from sensor and overlaid a new wire. Problem still exsits, I have inspected the sensor magnet and it looks good but have ordered a new one anyway. Am I missing something? Thanks, al
Do you
have the same problem?
Yes
No
Thursday, November 13th, 2008 AT 4:03 PM

1 Reply

Tiny
DAVE H
  • MEMBER
Could I ask why you are concentrating so much on the CKP sensor. What was the original fault?

NOTE:If replacing Powertrain Control Module (PCM), the correct vehicle mileage and Vehicle Identification Number (VIN) must be programmed into the PCM to prevent Diagnostic Trouble Codes (DTCs) from being set in the Anti-Lock Brake System (ABS) module and Supplemental Restraint System (SRS) module. To program PCM and clear DTCs from ABS and SRS modules, see PCM PROGRAMMING. If replacing Powertrain Control Module (PCM) on models equipped with a Smart Key Immobilizer Module (SKIM), the secret key data must also be updated to enable engine starting. To update secret key data.
Was this
answer
helpful?
Yes
No
Thursday, November 13th, 2008 AT 9:06 PM

Please login or register to post a reply.

Sponsored links