VALVE SEALS

  • Tiny
  • mikeredblack
  • Ford Probe

I am going to do an overhead valve seal job on my 1991 ford probe 2.2L. My repair book says to use a air compressor but I don't have. I was wanting to know if there was anything else I could use instead of the air compressor.

Do you
have the same problem?
Yes
No
Sunday, March 18th, 2007 AT 4:56 PM

1 Reply

  • Tiny
  • TaurusWheel
  • Member

Some other steady source of air pressure would be needed to hold up everything. You can pick up a pancake-type compressor relatively cheap.

Was this
answer
helpful?
Yes
No
Monday, March 19th, 2007 AT 12:17 AM

Please login or register to post a reply.

Similar Questions