I have a non power brake master cyllinder & propotioning valve out of a 1969 dodge charger in my 1952 studebaker pick up truck. I have replaced the master cyclinder with a brand new one because of leakage, I have bench bled the master cylinder and installed. I then started at the rear furthestt away and bled the system. The I moved to the front and did the same. I have did this over & over and can not get a good hard pedal. Is there some thing I am doing wrong? Some one said to take it to a brake place and have them use a power bleeder? The front of my truck is running drop spindles with large disk brakes the rear is a ford 9" rear end with drums.
have the same problem?
Friday, February 16th, 2007 AT 3:44 PM