1998 Chevy S-10 installing a passenger side window

Tiny
BFRAIZER
  • MEMBER
  • 1998 CHEVROLET S-10
Interior problem
1998 Chevy S-10 4 cyl Two Wheel Drive Automatic

how do you install a passenger side window in your chevy 1998 s10?

I have removed the old window witch was smashed in but I can seem to figure out how to get the new window in the roller up and down part it is manual not power
thanks
Bob
Do you
have the same problem?
Yes
No
Friday, March 12th, 2010 AT 12:16 PM

1 Reply

Tiny
DAVE H
  • EXPERT
Hello. Thanks for the donation. Much appreciated

WINDOW REGULATOR MOTOR
Removal & Installation
Disconnect negative battery cable. Remove power window switch. See WINDOW SWITCH. Remove door trim panel retaining screws. Using Trim Panel Remover (J-38778), pry retainers from door frame, and remove door trim panel. Remove armrest bracket. Remove water protection shield. Disconnect electrical connectors from motor.
Lower window half-way down. Remove window run channels and weatherstrip. Remove outer weatherstrip. Move window forward to release sash channel from rear regulator roller. Tilt window forward to vertical position, pull upward and remove window from door.
CAUTION:Sector gear must be locked into position. Regulator lift arm is under tension from counterbalance spring and could cause personal injury if sector gear is not locked in position.

Drill out rivets that secure window regulator to door. Remove window regulator. Drill hole through regulator sector gear and backplate. Install bolt and nut, locking sector gear into position. Drill out window motor mounting rivets. Remove motor from window regulator. To install, reverse removal procedure. Use 3/16" (4.8 mm) rivets to install motor and regulator.
Was this
answer
helpful?
Yes
No
-1
Friday, March 12th, 2010 AT 3:44 PM

Please login or register to post a reply.

Recommended Guides