ENGINE LITE CAME ON CUISE CONTROL STOP WORKING ...

  • Tiny
  • chev6.0
  • 2009 Chevrolet Silverado
  • 152,000 miles

Engine lite came on, Cuise control stop working, check 2 codes P0700 & P182e need to get fix. What is the problem, an how much will it cost me.$$$$$$$$$$$$$$

Do you
have the same problem?
Yes
No
Saturday, November 17th, 2012 AT 5:04 PM

3 Replies

  • Tiny
  • chev6.0
  • Member

P182e What am I looking at How much for repair

Was this
answer
helpful?
Yes
No
+1
Saturday, November 17th, 2012 AT 5:11 PM
  • Tiny
  • ASEMaster6371
  • Expert
  • 25,556 posts

DTC P0700

Diagnostic Instructions

Perform theDiagnostic System Check - Vehicle (See: Testing and Inspection Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
ReviewStrategy Based Diagnosis (See: Testing and Inspection Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
Diagnostic Procedure Instructions (See: Testing and Inspection Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.

DTC Descriptor
DTC P0700

Transmission Control Module (TCM) Requested MIL Illumination

Circuit/System Description

The transmission control module (TCM) uses the (GMLAN) to signal the engine control module (ECM) that the TCM is requesting malfunction indicator lamp (MIL) illumination. This happens when the TCM has determined that a failure affecting emissions has occurred in transmission control system. When the ECM receives the a message from the TCM, DTC P0700 will set.

Conditions for Running the DTC

DTC P182A, P182C-P182F, or P1915

Diagnostic Instructions

Perform theDiagnostic System Check - Vehicle (See: Testing and Inspection Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
ReviewStrategy Based Diagnosis (See: Testing and Inspection Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
Diagnostic Procedure Instructions (See: Testing and Inspection Initial Inspection and Diagnostic Overview)provides an overview of each diagnostic category.

DTC Descriptor
DTC P182A

Internal Mode Switch A Circuit Low Voltage

DTC P182C

Internal Mode Switch B Circuit High Voltage

DTC P182D

Internal Mode Switch P Circuit Low Voltage

DTC P182E

Internal Mode Switch - Invalid Range

once you have the diag completed and the failed part determined then and only then can an estimate be given. A code never identifies a bad part, just a failed system

Roy

Was this
answer
helpful?
Yes
No
Saturday, November 17th, 2012 AT 5:44 PM
  • Tiny
  • anon2
  • Member

Got these codes (P0700 AND P0182E) on my brand new 2015 Silverado LTZ.
Diagnosis: "Trans shift cable out of adjustment".
They adjusted the shift cable linkage. Nothing replaced.

Was this
answer
helpful?
Yes
No
Thursday, January 21st, 2016 AT 3:20 PM

Please login or register to post a reply.

Similar Questions