Hard steering

Tiny
SHOE128
  • MEMBER
  • 2008 CHEVROLET EQUINOX
  • 2.4L
  • 6 CYL
  • 2WD
  • AUTOMATIC
  • 78,000 MILES
My wifes car: suddenly the steering got hard, good thing she was on afarm rd.
iv check the fuses, and no bad ones
Do you
have the same problem?
Yes
No
Sunday, October 18th, 2015 AT 8:00 AM

11 Replies

Tiny
HMAC300
  • MECHANIC
  • 48,606 POSTS
Have a local pro scan for codes it may be the electric steering is screwed up.
Was this
answer
helpful?
Yes
No
-1
Monday, October 19th, 2015 AT 7:21 AM
Tiny
ROMEROJESUSE
  • MEMBER
  • 5 POSTS
The same thing happened to me! i was driving in the highway and suddenly my steering wheel clicked and my power steering was gone. I managed to drive it like that for a couple days while I researched what the problem might be. I finally gave up after numerous hours researching. I gave up and tried trouble shooting myself! So first thing i did was get it scanned a C460 code came up and i checked the fuse and it was fine. Since that wasn't the problem; with the car off I removed the cover for the electronic power steering motor and wiggled the wiring and made sure all the connector were probably seated and clicked. I turned the car on and it started working! The power steering was back! I did not disconnect the battery or anything I do not know if it a temporary or a permanent fix but I just started my 5th day after i did this and power steering is working fine! Saved me couple hundred of dollars of diagnostic and numerous headaches! It's worth the try!
https://youtu.be/e-jE_wxKOWY
Was this
answer
helpful?
Yes
No
Tuesday, February 19th, 2019 AT 7:20 AM
Tiny
KEN L
  • MASTER CERTIFIED MECHANIC
  • 42,468 POSTS
Excellent addition to this thread! Please feel free to help out whenever you are on the site :)
Was this
answer
helpful?
Yes
No
-1
Thursday, February 21st, 2019 AT 11:03 AM
Tiny
MISSLADY68
  • MEMBER
  • 1 POST
  • 2007 CHEVROLET EQUINOX
The service stibili trek came on steering is hard is this an expense repair
Was this
answer
helpful?
Yes
No
+1
Thursday, February 21st, 2019 AT 11:03 AM (Merged)
Tiny
ASEMASTER6371
  • MECHANIC
  • 52,797 POSTS
Dont even know what is wrong yet.

We need the code for the system to help you further.

Check the power steering fluid for the tight steering

Roy
Was this
answer
helpful?
Yes
No
Thursday, February 21st, 2019 AT 11:03 AM (Merged)
Tiny
ROMEROJESUSE
  • MEMBER
  • 5 POSTS
If your 80 Amp fuse was not the issue to the loss of your power steering and a faulty power steering motor does not appear when scanned; I recommend you to try and wiggle the wiring and make sure all the connector aren't loose on you Power steering motor located under the steering column as shown on the video. I do not know if it a temporary or a permanent fix but I just started my 5th day after i did this and it is working fine! Saved be couple hundred of dollars of diagnostic and numerous headaches! It's worth the try!
https://youtu.be/e-jE_wxKOWY
Was this
answer
helpful?
Yes
No
Thursday, February 21st, 2019 AT 11:03 AM (Merged)
Tiny
ASEMASTER6371
  • MECHANIC
  • 52,797 POSTS
Did you ever get the code for the system so I can help you further?

Roy
Was this
answer
helpful?
Yes
No
Thursday, February 21st, 2019 AT 11:03 AM (Merged)
Tiny
OROOFO
  • MEMBER
  • 1 POST
  • 2008 CHEVROLET EQUINOX
  • 98,099 MILES
Jump starting a friends car connected the positive to the post on the fuse box and as I was doing that the negative landed on the post to the rear of the fuse box causing it to arch. Hopped in the vehicle and everything seemed normal except no power steering. Replaced the 80 amp relay and still nothing. What should I do next?
Was this
answer
helpful?
Yes
No
Thursday, February 21st, 2019 AT 11:03 AM (Merged)
Tiny
WRENCHTECH
  • MECHANIC
  • 20,758 POSTS
Check fuse # 63 marked EPS, 80 amp.

If that fuse is good, then you likely fried the Steering Control Module
Was this
answer
helpful?
Yes
No
-1
Thursday, February 21st, 2019 AT 11:03 AM (Merged)
Tiny
ROMEROJESUSE
  • MEMBER
  • 5 POSTS
If your 80 Amp fuse was not the issue to the loss of your power steering try and wiggle the wiring on you Power steering motor and push in the connectors under the steering column. Do not know if it a temporary or a permanent fix. This might be a quick and easy fix. https://youtu.be/e-jE_wxKOWY
Was this
answer
helpful?
Yes
No
Thursday, February 21st, 2019 AT 11:03 AM (Merged)

Please login or register to post a reply.

Sponsored links