Ignition switch

Ok great I want to make sure that it is the throttle body first then I will write you back and let you know. That is the lowest Price that I have seen Thanks. If I put it in and the idel is high how do I make it relearn the throttle. Thanks.

I am not sure what is up with this truck I started it this morning after I put the battery back in. The truck runs normal. I took it for a 20 minute drive shut it off and I have started it 3 other times today. Any suggestions. If I find that the throttle body is bad I will order it from rock auto. Thanks for your time and help.

Ok so I cleaned out the airfilter and some other things The truck idels at 500 rpm which is good. Before I did that it was almost 750- 1000rpm. Before I cleaned the filter out when you started the truck and hit the gas it acts like it wants to die. It still does it after I cleaned everything out. Does this mean that the throttle body may be bad. Thanks.

No it is a fram

It ran but it ran heavy. Now it runs smooth. But when you step on the gas and raise the rpms it sounds like it wants to choke.

I already erased the codes none of them came back up. The codes that came up someone helped me with it. But here are the codes again The code P1682 ignition switch circuit could have been set from crqnking it without it starting and the battery voltage dropping too low. There is a bulletin for that code setting because of that condition. The P0300 is random missfire the P0443 is evap purge solenoid control circuit. The P0102 is mass air flow sensor performance. The P0102 can be caused by the same reason the P1682 can low battery voltage.I would have the battery tested make sure the alternator is charging properly also make sure the battery cables are clean and tight. Also have a back pressure test done to make sure you dont have a plugged cat. That could set a random missfire code the mass air flow code etc. Thanks.

Ok thanks. I will try it and let you know. If it does change what does that meen. Thanks for your time and help.

On that not I forgot my next door neighbor was helping me. He pushed on one of the connectors and it snapped in. I dont know the name of it but it finally corrected itself. Tat was when I first started working on it a week ago. Now it is just trying to dye when you touch the gas. Thanks.