Rear washer motor

Tiny
CALGARYTRUCKER
  • MEMBER
  • 2006 CHEVROLET OPTRA
  • 4 CYL
  • FWD
  • AUTOMATIC
  • 82,000 MILES
The rear window washer is not working! There is no sound when I push the washer arm. Is there a seperate fuse/resevoir/pump for the rear washer. 2006 Optra wagon
I have checked all the fuses. The front washer works fine
Monday, January 4th, 2010 AT 10:05 PM

11 Replies

Tiny
WALLYLESLIE
  • MEMBER
  • 5 POSTS
There is no rear wiper motor. The main motor does it all. I suspect that the plastic hose in the hatch has broken. You need find the broken line and replace it or splice in a new piece. You will probably find the break in the hose where it runs through the wiring harness where it goes from the body of the car into the hatch.
Was this
answer
helpful?
Yes
No
Friday, April 1st, 2011 AT 3:34 AM
Tiny
GRACE22
  • MEMBER
  • 1 POST
How much would it cost to replace or fix a broken hose for the Chevy Optra wagon 2006?
Was this
answer
helpful?
Yes
No
Wednesday, November 23rd, 2011 AT 10:07 PM
Tiny
WALLYLESLIE
  • MEMBER
  • 5 POSTS
You could probably get a garage to repair it for you for a $50. I wouldn't think it would cost more than that.
Was this
answer
helpful?
Yes
No
Wednesday, November 23rd, 2011 AT 10:45 PM
Tiny
CADIEMAN
  • MECHANIC
  • 3,544 POSTS
Remove the rear nozzle hose and see if water comes out when u use the washer. If so youll need a washer nozzle if you cant blow out the restrickion.
Was this
answer
helpful?
Yes
No
Wednesday, November 23rd, 2011 AT 11:16 PM
Tiny
WRENCHTECH
  • MECHANIC
  • 20,757 POSTS
We don't have specific information on that vehicle because it is not sold here but they NEVER use a single pump for both front and rear. It may use a combination reservoir but there will be 2 pumps and if you're not hearing a pump, it is probably bad.
Was this
answer
helpful?
Yes
No
Wednesday, November 23rd, 2011 AT 11:30 PM
Tiny
WALLYLESLIE
  • MEMBER
  • 5 POSTS
I can tell you I have replaced my pump already for this issue and it is a single pump. Just talking from experience.
Was this
answer
helpful?
Yes
No
Thursday, November 24th, 2011 AT 2:01 AM
Tiny
WRENCHTECH
  • MECHANIC
  • 20,757 POSTS
That wouldn't be possible. You have to have separate controls from front and rear. The rear washers don't shoot automatically when the front is activated. They just don't work that way.
Was this
answer
helpful?
Yes
No
Thursday, November 24th, 2011 AT 2:04 AM
Tiny
WRENCHTECH
  • MECHANIC
  • 20,757 POSTS
You may be right on this one. Looking at the wiring diagram for the Malibu Maxx which I think is close to the same car, it has a BCM controlled motor with switching front front to rear.
Was this
answer
helpful?
Yes
No
Thursday, November 24th, 2011 AT 2:19 AM
Tiny
WALLYLESLIE
  • MEMBER
  • 5 POSTS
Thats ok. It came as a surprise to me!
Was this
answer
helpful?
Yes
No
Thursday, November 24th, 2011 AT 2:36 AM
Tiny
CADIEMAN
  • MECHANIC
  • 3,544 POSTS
This is no plastic hose its rubber. If you dont hear the pump is running. Youll need a test light to check at the washer pump connecter for power coming from the switch.
Was this
answer
helpful?
Yes
No
Thursday, November 24th, 2011 AT 4:38 PM
Tiny
WRENCHTECH
  • MECHANIC
  • 20,757 POSTS
Power doesn't come from the switch. It sent from a rear wiper control module which is controlled by the BCM on a data bus line. Also it IS a plastic hose routed within the wiring harness to the rear.

From service manual

[quote]HOSE REPLACEMENT - REAR WINDOW - WASHER PUMP TO ENDGATE

REAR WASHER HOSE ROUTING
The rear washer hose is a component of the main body wire harness assembly. The rear washer hose is a hard plastic convoluted tube that is wrapped in the electrical tape along with the main body wiring harness. It starts underhood where it connects to the rear washer solvent container hose, this is rubber tubing. The rear washer hose routes into the main body wire harness underhood and passes through the front of the dash. The rear washer hose runs inside the vehicle interior along the left side rocker and over the left rear wheel housing. The rear washer hose is then routed up the left side pillar where it connects to the rear washer nozzle hose, where it is rubber tubing, at the top of the lift gate opening.[/Quote]
Was this
answer
helpful?
Yes
No
Thursday, November 24th, 2011 AT 4:49 PM

Please login or register to post a reply.

Sponsored links