Ethanol Contamination. Loss of power.

Tiny
TONOKLEIN
  • MEMBER
  • 2005 SUBARU IMPREZA
  • 4 CYL
  • AWD
  • AUTOMATIC
  • 83,000 MILES
This is a follow up to a couple of posts I’ve already made about this problem, so if it sounds familiar that’s why. Since then I’ve made some progress in narrowing down the solution.

To sum it up: almost two years ago to the day, my car got contaminated with ethanol and water. The car almost died. It was taking like 3k rpm just to maintain 60 mph, terribly weak, and it would almost stall when starting up or goosing the pedal to accelerate quickly. I replaced the fuel filter and that took care of most of the problem. But the car is still pretty weak.

What happens is I’ll hit the gas and it’s not as touchy as it was before this problem... Not as quick. In fact it’s really slow, like driving a Ford Fiesta or something. The half dozen mechanics I’ve taken it to think it’s fine. But it’s certainly not fine. My dealer thought it was fine before I replaced the fuel filter... When the car was taking 3000 rpm to get to 60. It may run well, but it’s not even close to as quick as it used to be. I bought the thing for the speed. Boxer engines are supposed to be quick off the gas.

Here’s a list of the repairs/service since then, some were necessary anyway:

tune up + new spark plugs
new fuel filter/pump (same assembly)
new battery (it was just about dead after all this)
air filter
drained fuel tank
new fuel pressure regulator
new mass air flow sensor
new oxygen sensor
new catalytic converter
replaced fuel filter again just in case
replaced transmission (it got burned out, needed to be replaced. Sounded like metal parts scraping together, gear slippage, etc.)
timing belt replacement (head gaskets were leaking too, so those got replaced at the same time)
new fuel lines
engine decompression test, which supposedly turned out negative for any problem. The pressure reading in a couple cylinders came out a touch higher than spec even. And he said the small difference in pressure shouldn’t be causing an issue. I wonder, though.

What little improvement was made after all this came after the oxygen sensor and fuel line replacements. Are there any other parts that come in direct contact with the fuel that I haven’t replaced, besides the engine?

I’m running out of options. Outside of the engine, the only systems left related to performance, that make sense, are the throttle and computer. I lean towards the throttle system as the next step, but I’m not a mechanic so I have no idea. I mean I did have to grind on it hard when this problem first occurred, almost pushing the pedal to the floor at times. After doing some research, I’ve come across the following throttle-related parts:

Cold Air Induction Kit/Cold air intake system
Throttle position sensor
Short ram intake?
MAP sensor?
Fuel injection air flow meter
Air/fuel ratio sensor
Fuel pressure gauge? Or is that the regulator I already replaced?

Could you explain the process of fuel delivery between the pedal and fuel injectors? And maybe rank these parts in the order of most likely problematic, if you had to guess?

I would be inclined to start the process of elimination with the pedal and move forward through the throttle system from there. I just have no idea what happens after the pedal. Maybe it’s something really simple about the pedal.

Could some electronic part have gotten knocked out of whack without triggering a code alarm? It’s electronic fuel injection.

I'm considering an engine replacement anyway, since I found an article on Pop Mechanics - "Can E15 Gasoline Really Damage Your Engine?"- That explained the reason behind my problem. It's called "phase separation."

(btw, someone is getting the bill for all these repairs)
Friday, July 1st, 2011 AT 8:32 PM

11 Replies

Tiny
TONOKLEIN
  • MEMBER
  • 21 POSTS
I forgot, I had the throttle body cleaned also. That provided a very small, but noticeable boost in power.
Was this
answer
helpful?
Yes
No
Friday, July 1st, 2011 AT 8:44 PM
Tiny
RIVERMIKERAT
  • MECHANIC
  • 6,110 POSTS
When you depress the accelerator pedal in a fuel injected engine, you open the throttle body butterfly valve, letting in more air. The throttle position sensor notices the pedal being depressed and signals the computer to do a couple of things:
1: First, it signals an injector to shoot a couple squirts of extra fuel to start the engine acceleration process.
2: Second, it increases the injector pulse-width, allowing more fuel in.
The injectors may either be clogged or not spray8ing the fuel properly. I would recommend a quality injector cleaner. My favorite is Techron.
Was this
answer
helpful?
Yes
No
Friday, July 1st, 2011 AT 9:42 PM
Tiny
TONOKLEIN
  • MEMBER
  • 21 POSTS
I apologize, I somehow missed that repair. I did replace the fuel injectors. That also lead to a very slight improvement in performance. So basically everything this ethanol touched it damaged. Is the throttle body the only other part besides the engine that comes in contact with the fuel which I haven't replaced?

Something else that goes on since this contamination - at start up there's a gurgling sound in the gas tank, lasting a few seconds. Could it be air bubbles, or fuel backflow?
Was this
answer
helpful?
Yes
No
Saturday, July 2nd, 2011 AT 6:13 PM
Tiny
RIVERMIKERAT
  • MECHANIC
  • 6,110 POSTS
Yes, it could be air bubbles or backflow. The throttle body doesn't normally come in contact with fuel in injected engines. Just with incoming air.
Was this
answer
helpful?
Yes
No
Saturday, July 2nd, 2011 AT 9:58 PM
Tiny
TONOKLEIN
  • MEMBER
  • 21 POSTS
It's most likely backflow. Any idea what would block the gas like that? Could a bad engine do that?
Was this
answer
helpful?
Yes
No
Thursday, July 7th, 2011 AT 6:38 PM
Tiny
RIVERMIKERAT
  • MECHANIC
  • 6,110 POSTS
No. Not that I've ever heard of. Without hearing the sound you're referring to, I'd lean more towards believing that what you're hearing is actually the fuel pump spooling up, which is normal.
Was this
answer
helpful?
Yes
No
Friday, July 8th, 2011 AT 4:32 PM
Tiny
TONOKLEIN
  • MEMBER
  • 21 POSTS
I think I've replaced the whole fuel system outside the engine and gas tank - fuel lines, fuel injectors, fuel pressure regulator, and fuel filter. Is there anything else left to replace that comes in contact with fuel which I haven't replaced?

Is the intake manifold part of the engine?
Was this
answer
helpful?
Yes
No
Friday, September 2nd, 2011 AT 7:11 PM
Tiny
TONOKLEIN
  • MEMBER
  • 21 POSTS
The fuel filter and pump are the same assembly, so the pump was replaced as well.
Was this
answer
helpful?
Yes
No
Friday, September 2nd, 2011 AT 7:18 PM
Tiny
RIVERMIKERAT
  • MECHANIC
  • 6,110 POSTS
The intake manifold is bolted to the cylinder head and (sometimes) the engine block. Do compression and leakdown tests to see if the ethanol damaged the rings or valves.
Was this
answer
helpful?
Yes
No
Friday, September 2nd, 2011 AT 8:06 PM
Tiny
TONOKLEIN
  • MEMBER
  • 21 POSTS
Well I have good news and bad news. My suspicion was confirmed. Every part this stupid ethanol touched was damaged. I replaced the engine, and some performance returned. I replaced the throttle body and more performance was restored. But you’re not going to believe this - there’s STILL a hang-up. The car wants to stay in a higher gear. It's always done this but I didn't pay too much attention until now. For example, when I come to a stop, the car doesn’t shift all the way down to first gear. It wants to stay in second gear, so I have to crank on the gas to get it to downshift and take off.

This must have something to do with the unusually long time it takes to warm up, even in warm months. It’s like the fire isn’t burning hot enough. The only explanation at this point, as far as I know, is an air problem. Do you think the idle air control valve could be messed too? I know transmissions automatically up shift when pressure drops, and a lack of air could cause reduced pressure. That seems to explain the quicker up shifts and inability to downshift normally.

I don’t know if this will help or not, but I distinctly remember this abnormal shifting being the first problem the car experienced when the ethanol/water began to flush through the system two years ago. The car was quicker to up shift, then slowly lost power over the next week, and almost crapped out completely by the end of that bad tank of gas. FYI
Was this
answer
helpful?
Yes
No
Wednesday, November 2nd, 2011 AT 1:19 AM
Tiny
RIVERMIKERAT
  • MECHANIC
  • 6,110 POSTS
It's possible the IAC is at fault. Is there a kickdown cable attached to the throttle assembly? If so, try adjusting it.

Find a shop that will perform a soft and hard code scan for free or for cheap. Also see if they can read live data. As far as I remember, vacuum modulators haven't been used for a number of years. Since before you car was manufactured, I'm pretty sure.
Was this
answer
helpful?
Yes
No
Wednesday, November 2nd, 2011 AT 3:37 AM

Please login or register to post a reply.

Sponsored links