'05 GMC 6.0 coolant system

2005 GMC YUKON
93,000 MILES • V8 • AWD • AUTOMATIC
Avatar
BUBBALARS
  • MEMBER
  • 2 POSTS
Just replaced the water pump on our 05 yukon denali 6.0, does the coolant system have a certain procedure for bleeding air out of the system.
Jun 27, 2011 at 2:51 AM
Advertisement
Avatar
SATURNTECH9
  • CAR REPAIR CONTRIBUTOR
  • 30,869 POSTS
I posted the filling directions for that engine iam still looking for the bleeder screw locations unless you already know where there at.
Images (Click to enlarge)
Attached Media
Attached Media
Jun 27, 2011 at 4:22 AM
Avatar
BUBBALARS
  • MEMBER
  • 2 POSTS
Thanks for the fast response! I did not know if there were bleeder screws, so that would be helpful also.
Jun 27, 2011 at 1:18 PM
Avatar
FACTORYJACK
  • CAR REPAIR CONTRIBUTOR
  • 4,159 POSTS
There are no bleeder screws, it should self bleed.
Jun 27, 2011 at 3:07 PM
Avatar
SATURNTECH9
  • CAR REPAIR CONTRIBUTOR
  • 30,869 POSTS
Thanks for clearing that up gstacey ondemand isnt always right its nice when someone can correct there mistakes from personal experince.
Jun 27, 2011 at 4:05 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.