I have a 2005 Dodge Ram 1500 Laramie SLT that.

Tiny
ANONYMOUS
  • 2005 DODGE RAM
  • 98,000 MILES

I have a 2005 Dodge Ram 1500 Laramie SLT that has a 40/20/40 bench seat in it. The driver's part of the seat is manual. Can I take a power seat out of a 2006 truck (same model) that is also a 40/20/40 and have it work:

1. Are the bolt hole patterns the same?
2. Does the fuse block accomodate the switch?
3. Do I have to get the harness from the seat assembly that goes to the main wiring harness?

The fabric color and pattern is an exact match as well.

Thanks!

SPONSORED LINKS
Thursday, December 27th, 2012 AT 1:35 PM

1 Reply

Tiny
HMAC300
  • EXPERT
  • 49,211 POSTS

You will need a lot the seat will bolt in and the switch will be on the seat, yo will need the harness and then a relay and seperate fuse lot of work jsut to move a seat every once in a while.

Was this
answer
helpful?
Yes
No
Thursday, December 27th, 2012 AT 3:30 PM

Please login or register to post a reply.

Related Fuse Panel Wiring Questions

2005 Dodge Ram Fuel Pump Body Harness

Electrical Problem 2005 Dodge Ram V8 Four Wheel Drive Automatic 43000 Miles I Recently Had Work Done On My Truck By A Local Dealership...
Asked by onelastride ·
1 ANSWER
2005
DODGE RAM

Ram 1500 Reg Cab 4x4 5.9litre. I Have A Bad Wire At...

Ram 1500 Reg Cab 4x4 5.9litre. I Have A Bad Wire At Fuse Block Under Hood. It Turns Fuel Pump Off. If I Grab Wires And Wiggle While Manually...
Asked by elarson1 ·
1 ANSWER
1 IMAGE
1999
DODGE RAM

2005 Dodge Ram "no Bus"

Electrical Problem 2005 Dodge Ram V8 Two Wheel Drive Automatic 43000 Miles A "no Bus" Signal Came Up In The Odometer Area Of...
Asked by volfan2009 ·
1 ANSWER
2005
DODGE RAM

Fuse Box Location

Where Is The Fuse Box Located On A 84' Dodge Ram Prospector
Asked by maquoketa ·
1 ANSWER
DODGE RAM

Recommended articles