Here is the procedure.
BLOWER MOTOR REPLACEMENT
Remove the right side sound insulator.
Remove the instrument panel (I/P) compartment.
Remove the dash integration module (DIM) from the bracket.
Remove the 2 rear DIM bracket fasteners.
Reposition the DIM bracket in order to remove the blower motor.
Disconnect the electrical connector (1) from the blower motor.
Disconnect the blower motor ventilation tube (2) from the module.
Remove the blower motor retaining fasteners (1).
Remove the blower motor from the vehicle.
Install the blower motor into the blower motor housing.
Ensure that the blower motor gasket is properly aligned.
Install the blower motor retaining screws (1).
Tighten the screws to 1.4 N.M (12 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
Connect the electrical connector (1) to the blower motor.
Connect the blower motor ventilation tube (2) to the module.
Reposition the DIM bracket to its original position.
Install the 2 rear DIM bracket fasteners.
Install the DIM.
Install the I/P compartment.
Install the right side sound insulator.
Friday, February 11th, 2011 AT 6:17 AM