2004 Ford Ranger transmission

Tiny
CHARLES72390
  • MEMBER
  • 2004 FORD RANGER
  • 3.0L
  • V6
  • 2WD
  • MANUAL
  • 150,000 MILES
The truck will shift into all gear positions when the motor is off but when the motor is on it feels like you hit a wall trying to shift to first third fourth fifth and reverse second still goes through but the gears don't stop spending so that just grinds the clutch pedal feels extremely soft I can push it all the way of the fire wall with just two fingers I've already changed the master cylinder and the slave cylinder assuming that they were not throwing out the clutch I got all the parts put back on yesterday and I have the same issue I'm not exist in clutch pedal and it's impossible to shift gears with the motor running I've never had this issue with any vehicle before and I cannot figure out what it is the owner says that it wouldn't shift into second gear before this happened but I don't know what they mean it won't shift into gear I'm not sure where to go and how did I get a bad master or slave cylinder or is this issue somewhere else. I've heard that the shafts on the crank can get bent but the transmission slid on an off with no real issue. I don't know what the problem could be I'm not very good with manual transmissions I've only worked on 4 in my entire 25 year life and this is the first I'm attempting alone and I'm pretty lost now.
Do you
have the same problem?
Yes
No
Sunday, November 15th, 2015 AT 7:38 AM

1 Reply

Tiny
HMAC300
  • EXPERT
Try bleeding clutch system first.
Was this
answer
helpful?
Yes
No
Sunday, November 15th, 2015 AT 8:23 AM

Please login or register to post a reply.

Recommended Guides