BECOME A MEMBER
Sign up with Facebook
I agree to the
Login with Facebook
NOT A MEMBER?
After changing the battery, how can you reset.
2004 FORD EXPLORER
After changing the battery, how can you reset the security system without a key transponder so the car will start
Wednesday, November 21st, 2012 AT 3:14 AM
Try rermoving a battery cable, turn the ignition to the on position, and then install the cable.
Wednesday, November 21st, 2012 AT 3:15 AM
to post a reply.
Related Battery Replace/Remove Content
Last Week I Went Out To Start My Suv. Turned Key And...
Last Week I Went Out To Start My Suv. Turned Key And Dummy Lights Came On And Dinged And Turned Key To Turn Over And Everything Went Dead....
2004 Ford Explorer Replace With New Battery Still Won...
Electrical Problem 2004 Ford Explorer 6 Cyl Four Wheel Drive Automatic 87000 Miles My Lights Where On For About 20 Minutes. I Try To...
2000 Ford Explorer Changing Battery
I Was Having Battery Issues So I Replaced The Battery. However, Whenever I Connect The Negative Cable, The Horn Goes Off, The Headlights...
Trying To Remove Positive Battery Shield
My Battery Is Dead And I Cannot Get This Shield Off The Battery. I Cannot Find Any Schematics On The Web. The Problem Is The Little...
2003 Ford Explorer Remove Battery
Engine Problem 2003 Ford Explorer V8 Wheel Drive Type Unknown Automatic 82300 Miles How Do You Remove The Battery From A 2003 Ford...
Ask a Car Question. It's Free!
Battery Jump Start
Battery Jump Starter
Find a car manual for your car
© 1999 - 2017 2CarPros, Inc.