2003 JEEP LIBERTY SPORT

  • Tiny
  • tholmstrom
  • 2003 Jeep Liberty
  • 6 CYL
  • 4WD
  • automatic

How to replace a blower motor resistor switch

Monday, November 29th, 2010 AT 9:38 PM

2 Answers

  • Tiny
  • rasmataz
  • Member

The blower motor resistor is mounted to the rear side of the HVAC housing on the passenger side of the vehicle.

Disconnect and isolate the battery negative cable.
Open the glove box door to gain access to the blower motor resistor.
Pull out the lock on the blower motor resistor wire harness connector to unlock the connector latch.
Depress the latch on the blower motor resistor wire harness connector and unplug the connector from the resistor.
Remove the two screws that secure the resistor to the HVAC housing.
Remove the resistor from the HVAC housing.

Was this
answer
helpful?
Yes
No
Monday, November 29th, 2010 AT 9:43 PM
  • Tiny
  • tholmstrom
  • Member

Thank you very much!

Was this
answer
helpful?
Yes
No
Monday, November 29th, 2010 AT 9:46 PM

Please login or register to post a reply.

Similar Questions