On 4x2 vehicles: The disc brake caliper (2B120) bolts to the front wheel spindles (3105).
The brake disc and hub is an integrally cast assembly.
On 4x4 vehicles: The disc brake caliper bolts to the front wheel knuckle (3K186).
A separate brake disc (1125) attaches to the wheel hub (1104).
The disc brake caliper: is a pin slider, dual piston type.
Has two caliper pistons (2196).
The caliper housing has a fluid inlet at the center of the bore. A square section seal fitted into an annular groove in the caliper cylinder bore seals against hydraulic pressure, while rubber boots seal the caliper pistons and caliper bore from contamination.
The brake disc shield (2K005): bolts to the front wheel spindle.
Protects the bearings and inboard surface of the brake disc.
The pads are: contained within the front disc brake caliper anchor plate (2B292).
Held to the front disc brake caliper anchor plate abutments by disc brake anti-rattle clips.
January, 6, 2011 AT 9:52 PM
Have you called the dealer?
January, 6, 2011 AT 9:53 PM
We posted simultaneously.
January, 6, 2011 AT 10:04 PM
Just lost the bolt yesterday and haven't had time to call them. Just sent them a request to order the bolts. Thank you very much for your quick response!
January, 7, 2011 AT 6:58 PM
The dealership says that 6 N808236-S36 Front brake hose bolt isn't made any more and that he doesn't see this one either.1 N805163-190 Front disc brake caliper anchor plate bolt. He does though have N805163-s100 which is an anchor bolt. I need to find out if that will still work.