Pcm problem

Tiny
BOB50
  • 2003 FORD ESCAPE
  • 6 CYL
  • 4WD
  • AUTOMATIC

Hi I have a ford escape 2003 3.0 Lt. Got the truck in a no start state. Changed the power control module, had it reprogrammed, worked fine. Then I changed the rear exhaust manifold and alternator and oil pan gasket. When I was done I fired it up. It started and then died. Now there is power to dash and engine won't turn over. Can' get into computer with my scanner, so its the module that burned again. Ever experienced something to this effect?

Do you
have the same problem?
Yes
No
Thursday, April 21st, 2011 AT 11:03 PM

1 Reply

Tiny
WRENCHTECH
  • EXPERT
  • 20,684 POSTS

You would have to pin test all the power supplies to it to determine that.

Please consider a donation to help us answer more questions.
Was this
answer
helpful?
Yes
No
Thursday, April 21st, 2011 AT 11:58 PM

Please login or register to post a reply.

Related Engine Computer PCM Read Code Questions

Help us by donating