IM STUCK IN THE MIDDLE OF REPLACING A BEARING ON...

  • Tiny
  • Anonymous
  • 2003 Dodge Dakota
  • 150,000 miles

Im stuck in the middle of replacing a BEARING on the INSIDE of the front DIFFERENTIAL on my 2003 4.7L V8 Dakota, I have the CV shaft off, diff cover off, but it appears to get the bearing out I need to remove the 'snub shaft'/'half shaft'. Now the CV shaft was retained on the 'snub shaft' by a small c-ring which the CV shaft slid over and 'snapped' into place. Im curious if there is another ring on the inside of the diff to keep the shaft in place, and if so HOW DO I FINISH THIS JOB? (PREFERABLY W/O USING A SPECIAL 'SHAFT PULLER' DEVICE)

Tuesday, December 11th, 2012 AT 8:33 PM

1 Answer

  • Tiny
  • ASEMaster6371
  • Expert
  • 25,502 posts

Attached a parts explosion. Yes, there is a c clip in the rear that has to be released.

Roy

Was this
answer
helpful?
Yes
No
Wednesday, December 12th, 2012 AT 1:27 AM

Please login or register to post a reply.

Similar Questions