No 12 Volt signal to ignition coil

Tiny
BILLY C
  • MEMBER
  • 2002 CHRYSLER SEBRING
  • 125,000 MILES
Help needed 2002 Chrysler sebring no 12 volt signal to ignition coil have installed new cam & crank sensors new ignition switch used computer. Checked with mt2500 scanner cranking over engine I get Dis-cam&crank Cam-present Crank-present Asd relay-on Fuel pump relay-on Current-lost. Any Chrysler experts out there?
Do you
have the same problem?
Yes
No
Saturday, February 4th, 2012 AT 3:15 PM

1 Reply

Tiny
RASMATAZ
  • MEMBER
Have you tested the ASD relay? Also any of the major sensors can short and cause the engine to not pulse. Disconnect all O2 and tps sensors to retry.
Was this
answer
helpful?
Yes
No
Saturday, February 4th, 2012 AT 4:33 PM

Please login or register to post a reply.

Recommended Guides