2001 Toyota 4Runner check engine light and Code 440

2001 TOYOTA 4RUNNER
130,000 MILES • 6 CYL • 4WD • AUTOMATIC
Avatar
CGREGORYAZ
  • MEMBER
  • 1 POST
The Check Engine and VSC lights came on and
I had the codes read at a autoparts store. It came back as a 440 code. I replaced the Gas cap as per their recommendation (non OEM)and reset the lights, by disconnecting the battery cables for 15 minutes. The warning lights seem to be connected to the fuel level. After filling the truck up with the lights reset, they will illuminate at about 3/4 of a tank. No other symptoms, as the truck runs and drives great. It just keeps firing these lights.
Apr 15, 2011 at 12:44 PM
Advertisement
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
A code P0440 could mean one or more of the following has happened:

•The gas cap is not installed or working properly
•The purge solenoid has failed
•The canister is plugged and not working properly
Possible SolutionsWith a P0440 OBD-II trouble code, diagnosis can be tricky at times. Here are some things to try:

•Remove and reinstall the gas cap, clear the code, and drive for a day and see if the codes come back.
•Inspect the EVAP system for cuts/holes in tubes/hoses
•Inspect for damaged or disconnected hoses around the Evap purge solenoid
•Check and/or replace the sensor
•Check and/or replace the purge valve
•Have a professional use a smoke machine to detect leaks
Apr 15, 2011 at 3:42 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.