01 JEEP CHEROKEE "NO BUS"

  • Tiny
  • j.stieg
  • 2001 Jeep Cherokee
  • 130,000 miles

Engine had just been exchanged with a 98 4.0l, and installed. Got the engine running after adjusting the distributor. The engine seem to stall suddenly sometimes like there is an ignition failure.
On the dash it says "no bus" and most if not all of the gauges do not work. I can not scan for codes because of linking error.

What would cause a "NO BUS" condition?

Do you
have the same problem?
Yes
No
Tuesday, June 26th, 2012 AT 9:19 PM

3 Replies

  • Tiny
  • rasmataz
  • Member

Seems to me the cluster has lost its communication with the computer-have the computer checked and tested

Was this
answer
helpful?
Yes
No
Tuesday, June 26th, 2012 AT 9:31 PM
  • Tiny
  • j.stieg
  • Member

It was a ground wire not in place on the block.

Was this
answer
helpful?
Yes
No
Monday, July 2nd, 2012 AT 5:27 PM
  • Tiny
  • rivermikerat
  • Member

Thank you for letting us know. Closing thread.

Was this
answer
helpful?
Yes
No
Friday, July 20th, 2012 AT 1:51 AM

Please login or register to post a reply.

Similar Questions