NOTE:Programming of IVIS keys is necessary when ignition key, IMMU or ECM are replaced.
Nissan CONSULT scan tool and Program Card (NATS UEN99A) must be used to register (program) additional keys. See CONSULT operation manual for key registration procedure. It may be necessary to register original keys when registering a NEW key. CHAIN OF ECM-IMMU may be displayed by scan tool during key registration even if system is not malfunctioning.
SECURITY INDICATOR LIGHT DOES NOT ILLUMINATE
Inspect fuse No. 12 (10-amp) in junction block fuse block. Replace as needed. If fuse is okay, go to next step.
Perform ignition key programming. See IMMU INITIALIZATION under PROGRAMMING. Start engine. Turn ignition switch off. If security indicator light is illuminated, system is functioning correctly. If security indicator light is not illuminated, go to next step.
Disconnect security indicator light connector. Measure voltage between ground and terminal No. 1 (Yellow/Red wire) on security indicator light harness connector. If battery voltage is present, go to next step. If battery voltage is not present, inspect and repair Yellow/Red wire for open or short.
Inspect security indicator light bulb. Replace as needed. If bulb is okay, go to next step.
Ensure IMMU harness connector is connected. Disconnect security indicator light harness connector. Check continuity between ground and terminal No. 5 (Green/Orange wire) on IMMU harness connector. See Fig. 3. If continuity is intermittent, inspect and repair Green/Orange wire for open or short. If continuity is not intermittent, replace IMMU.
NOTE:If a new Smart Entrance Control Module (SECU) is installed, a new identity code must be entered and all remote controllers must be programmed. If identity code cannot be entered, repair multi-remote system. See appropriate MULTI-REMOTE CONTROL SYSTEMS article.
PROGRAMING NEW ID CODE
NOTE:This procedure will erase all previous identity codes and render all previously programmed remote controllers inoperative (until reprogrammed). All remote controllers to be used with system must be programmed at the same time.
NOTE:A maximum of 4 remote controllers can be programmed. Any attempt to program more than 4 controllers will be ignored. If same identity code is entered more than once, entry is ignored even though hazard warning lights will still flash twice.
Close and lock all doors. Erase original identity code(s) by inserting and completely removing key from ignition switch more than 6 times within 10 seconds. Hazard warning lights should flash twice. Turn ignition switch to ACC position.
Push any button on new remote controller once. Hazard warning lights should flash twice, indicating identity code has been entered. If identity code cannot be entered, repair multi-remote system. See appropriate MULTI-REMOTE CONTROL SYSTEMS article.
For each additional remote controller to be programmed, manually release door lock and lock again by using door panel switch and repeat step 2. If no additional remote controllers are to be used, exit programming mode by unlocking and opening driver's door.