SPONSORED LINKS

Where is the EVAP system purge valve located on.

Tiny
JIMLANGE
  • MEMBER
  • 2002 HYUNDAI SONATA
  • 136,000 MILES
Where is the EVAP system purge valve located on the 2.4L engine. Was told at dealer it was behind intake manifold. I have looked all over and cannot find it. Car will not take fuel. Replaced charcoal canister & checked solenoid by canister. Purge valve is last piece.
SPONSORED LINKS
Wednesday, December 19th, 2012 AT 3:57 PM

5 Replies

Tiny
KEN L
  • MASTER CERTIFIED MECHANIC
  • 42,861 POSTS
Hello,

The evap solenoid is located and the bend of the intake manifold. Here is a diagram (below) that will how you where.

The evap canister purge solenoid solenoid on the engine isn't going to cause it to not take fuel when filling the tank. All it does is allow vacuum to be applied to evap system your vent valve controls the tanks vent by the gas tank. Are you sure thats not stuck closed?

Please let us know what happens.

Cheers, Ken
Image (Click to make bigger)
Thumb
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Wednesday, December 19th, 2012 AT 4:06 PM
Tiny
2CP-ARCHIVES
  • MEMBER
  • 4,542 POSTS
  • 2002 HYUNDAI SONATA
  • 20,700 MILES
Have been told I have to replace the purge control valve but have no idea where it is and have had no luck online. Please help.
Was this
answer
helpful?
Yes
No
-1
Tuesday, March 6th, 2018 AT 5:42 PM (Merged)
Tiny
KHLOW2008
  • MECHANIC
  • 41,815 POSTS
Which engine do you have?
The diagram is for a 2.4L engine. For 2.7L it is near top right side of of intake manifold, similar location.
When there is a code, replacing components might not solve the problem and you should test the solenoid first before replacing it as it might not be the cause.
Image (Click to make bigger)
Thumb
Was this
answer
helpful?
Yes
No
+2
Tuesday, March 6th, 2018 AT 5:42 PM (Merged)
Tiny
BBURBES
  • MEMBER
  • 1 POST
  • 2001 HYUNDAI SONATA
  • 84,000 MILES
Sonata V6 starts fine when car is cold and when car is at normal running temperature. It stalls a couple of times if you let it set for 15 - 20 minutes, but it eventually starts. Battery and purge control valve have been replaced. Fuel pressure (41 psi), fuel injectors and starter check out OK. What could be causing this?
Was this
answer
helpful?
Yes
No
Tuesday, March 6th, 2018 AT 5:42 PM (Merged)
Tiny
KHLOW2008
  • MECHANIC
  • 41,815 POSTS
Are there any trouble codes?
When it stalls, were you able to restart with pressure on the accelerator pedal?
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Tuesday, March 6th, 2018 AT 5:42 PM (Merged)

Please login or register to post a reply.

Related EVAP Purge Solenoid Content

Sponsored links