SPONSORED LINKS

Continous blown fuses

Tiny
CBRASHAW
  • MEMBER
  • 2000 FORD RANGER
  • 6 CYL
  • 2WD
  • MANUAL
  • 150,000 MILES
Ok so I have a 2000 Ford Ranger manual v6 3.0L. A week ago the alternator volt regulator fuse blew. I replaced it along with the battery bc it was bad as well. Today the fuse blew and everytime I try to replace it the fuse blows before I can even get it in good. Auto part guy said my battery was the correct one and that my alternator was fine
SPONSORED LINKS
Monday, June 20th, 2011 AT 4:04 AM

14 Replies

Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Disconnect/unplug connector/ all the wires on the alternator and try the fuse again
Was this
answer
helpful?
Yes
No
-2
Monday, June 20th, 2011 AT 4:19 AM
Tiny
CBRASHAW
  • MEMBER
  • 8 POSTS
Took the two wiring harnesses off but not the bolted wire in the back of the alternator and still did same thing do I need to take the bolted down wire off?
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Monday, June 20th, 2011 AT 4:34 AM
Tiny
CBRASHAW
  • MEMBER
  • 8 POSTS
Hey there boss. I unplugged and disconnected everything. Still blowing the mini 30a fuse everytime I touch the receptacle. Believe it is spot 15 under the hood fuse box
Was this
answer
helpful?
Yes
No
Monday, June 20th, 2011 AT 4:47 AM
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Which fuse is blowing?-Is it fuse no.15 7.5 or the Alternator system fuse-?
Was this
answer
helpful?
Yes
No
+3
Monday, June 20th, 2011 AT 4:50 AM
Tiny
CBRASHAW
  • MEMBER
  • 8 POSTS
It is the alternator voltage regulator fuse it is a 30a mini can't remember the # want me to look?
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
-1
Monday, June 20th, 2011 AT 4:51 AM
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Verify the yellow and white wire to terminal A on the alternator is not shorted directly to ground-use a DVOM
Was this
answer
helpful?
Yes
No
Monday, June 20th, 2011 AT 5:06 AM
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Here's the charging system EWD
Image (Click to make bigger)
Thumb
Was this
answer
helpful?
Yes
No
+2
Monday, June 20th, 2011 AT 5:08 AM
Tiny
CBRASHAW
  • MEMBER
  • 8 POSTS
Ok I don't have a voltmeter. I know. I suck
Was this
answer
helpful?
Yes
No
Monday, June 20th, 2011 AT 5:08 AM
Tiny
CBRASHAW
  • MEMBER
  • 8 POSTS
Looking at the diagram. The battery light is working, so the malfunction most likely is coming from the yellow line? Considering it is the only line that runs through the 30a?
Was this
answer
helpful?
Yes
No
Monday, June 20th, 2011 AT 5:16 AM
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Get going and let me know the status
Was this
answer
helpful?
Yes
No
Monday, June 20th, 2011 AT 5:18 AM
Tiny
CBRASHAW
  • MEMBER
  • 8 POSTS
Is the voltage regulator inside the alternator or outside?
Was this
answer
helpful?
Yes
No
Monday, June 20th, 2011 AT 5:30 AM
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Its integral with the alternator
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Monday, June 20th, 2011 AT 6:31 AM
Tiny
CBRASHAW
  • MEMBER
  • 8 POSTS
I still gotten anyone with a voltmeter to check the wires, but I re tested the alternator today at autozone which it checked as good. Also I replaced the voltage regulator and still getting results. Considering the battery, alternator, and voltage regulator are good, it has to be a short in the wiring or relay? That's what someone told me, but I'd rather have your opinion. Also, if this is the case, I have no idea how to start checking this
Was this
answer
helpful?
Yes
No
Monday, June 20th, 2011 AT 9:55 PM
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Do a continuity check with an ohmmeter set at RX1- remove the fuse and unplug the connector where the yellow wire is-now put one lead of the ohmmeter on the yellow wire and the other lead to ground if you get a reading -the wire is shorted to ground
Was this
answer
helpful?
Yes
No
Monday, June 20th, 2011 AT 10:40 PM

Please login or register to post a reply.

Related Fuse Test Content

VIEW MORE

Sponsored links