SPONSORED LINKS

Neutral Safety Switch

Tiny
FOLDERQUEEN
  • MEMBER
  • 2000 BUICK LESABRE
I just found out that the neutral safety switch has gone out on my 2000 Buick Lesabre. Does anybody have any idea how much this is going to cost to repair?
Monday, January 28th, 2008 AT 5:04 PM

7 Replies

Tiny
ANDY10139
  • MEMBER
  • 2 POSTS
I just replaced the safety switch in my Buick and the switch only costed me $30, but I installed it my self. Check out the diagrams (Below). Please let us know if you need anything else to get the problem fixed.
Image (Click to make bigger)
Thumb
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
+2
Tuesday, May 6th, 2008 AT 8:44 AM
Tiny
WILDLIFE ENTHUSIAST
  • MEMBER
  • 3 POSTS
  • 2000 BUICK LESABRE
  • 6 CYL
  • AUTOMATIC
2000 Buick Lesabre. When cold the car runs fine, after say five minutes it will not go as if in idle, but only after a stop. Wait 3 minutes and it goes. It always starts, just wont go in any gear after a stop light when warmed up. No code appears except for map air sensor. Was told Neutral saftey switch is prob. Cause. What do you think? Thank You
Was this
answer
helpful?
Yes
No
Tuesday, August 20th, 2019 AT 1:55 PM (Merged)
Tiny
SATURNTECH9
  • MECHANIC
  • 30,870 POSTS
What is the exact code number you have not the code description.
Was this
answer
helpful?
Yes
No
Tuesday, August 20th, 2019 AT 1:55 PM (Merged)
Tiny
WILDLIFE ENTHUSIAST
  • MEMBER
  • 3 POSTS
Advance didn't really say, other than a mass air sensor because the car had another issue.
But this problem isn't giving a code at all. It just won't go after a stop, shut off engine 2-3 min
and it goes UNTIL a stop again so I just pull over knowing what will happen.
And where is NSS located if it's the fault, thank you, Saturntech9
Was this
answer
helpful?
Yes
No
+1
Tuesday, August 20th, 2019 AT 1:55 PM (Merged)
Tiny
SATURNTECH9
  • MECHANIC
  • 30,870 POSTS
If you follow your shifter cable it will lead you straight to the nss. Have you had your battery tested made sure your battery cables are clean and tight and had your alternator tested?Just to cover those bases?Also are sure there are no transmission codes?Is that mass air flow code active meaning does it coming back when its cleared?
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Tuesday, August 20th, 2019 AT 1:55 PM (Merged)
Tiny
WILDLIFE ENTHUSIAST
  • MEMBER
  • 3 POSTS
Thankyou for follow up, so greatly appreciated. However, took it to a recommended trans repair shop and in my terms from them is hydraulics aren't working, metal in pan and they are doing a rebuild. Plus it did finally quit going at all and made a bad noise.
Cost for overhauling trans is better than junkyard bought and taking chances I guess
Was this
answer
helpful?
Yes
No
Tuesday, August 20th, 2019 AT 1:55 PM (Merged)
Tiny
SATURNTECH9
  • MECHANIC
  • 30,870 POSTS
Yeah metal in the pan is never a good thing to see keep me posted on how it comes out.
Was this
answer
helpful?
Yes
No
Tuesday, August 20th, 2019 AT 1:55 PM (Merged)

Please login or register to post a reply.

Related Transmission Gear Position Sensor Content

Neutral Safety Switch Test
GUIDE
Neutral Safety Switch Test
The functionality of the neutral safety switch has changed greatly through the automotive development era, what was once a simple switch for the reverse lights and starter...
VIEW MORE

Sponsored links