Removal & Installation
Remove negative battery cable.
Drain cooling system.
Remove right side front end diagonal brace.
Remove battery hold down retainer and remove battery.
Remove battery tray.
Remove washer reservoir.
Reposition underhood accessory wiring junction block.
Remove accessory drive belt.
Remove power steering pump pulley.
Remove accessory drive belt idler pulley.
Remove drive belt tensioner.
Remove water pump pulley bolts and remove pulley.
Remove water pump bolts.
Remove water pump drive belt shield.
Remove water pump and housing assembly.
To install, reverse removal procedure.
At bottom of tensioner bracket you would notice a square slot. Use a socket wrench handle to insert in and turn anticlockwise to loosen the tension on the belt to enable removing it.
Sunday, December 26th, 2010 AT 12:44 PM