BECOME A MEMBER
Sign up with Facebook
I agree to the
Login with Facebook
NOT A MEMBER?
Clutch pedal assembly removal and installation.
1999 MAZDA 626
Clutch pedal assembly removal and installation for a mazda 626
have the same problem?
Monday, November 26th, 2012 AT 7:15 PM
Disconnect the master cylinder push rod.
Remove holding bolt/nut and you can take the pedal out. Note the spring position before removal.
Please consider a donation if we helped you
Tuesday, November 27th, 2012 AT 6:39 PM
to post a reply.
Related Transmission Clutch Pedal Replace/Remove Questions
1996 Mazda 626 Clutch Pedal Sticking Down
Engine Mechanical Problem 1996 Mazda 626 4 Cyl Two Wheel Drive Manual 254000 Miles Ok, So From What I Understand So Far, I Could...
Is It The Torque Converter?
Shifts Fine Until Operating Temperature. Would Shift Into Neutral At Stop Signs. Would Eventually Shift Into 1st Hard At About 1200 Rpms...
1999 Mazda 626 Transmission Problems
1999 Mazda 626 Automatic 116000 Miles We Had The Transmission Replaced. Car Then Would Rev Up To High Rpm But Wouldn't Accelerate....
1999 Mazda 626 Jerks & Pulls
Transmission Problem 1999 Mazda 626 4 Cyl Ive Had My Transmission Rebuilted Twice In The Last Year, By Two Different Mechanics. The...
Ask a Car Question. It's Free!
Clutch/Flywheel/Rear Main Seal Replacement
Throwout Bearing Replacement
Find a car manual for your car
© 1999 - 2017 2CarPros, Inc.