SPONSORED LINKS

VEHICLE DOES NOT START AFTER INJECTOR ...

  • Tiny
  • williamwmaina
  • 1998 Toyota Prado
  • 70,000 miles

Vehicle does not start after injector caribration and fitted new nozzles and engine is cranking okey.

Do you
have the same problem?
Yes
No
Wednesday, October 24th, 2012 AT 8:43 PM

1 Reply

  • Tiny
  • KHLow2008
  • Expert
  • 41,994 posts

Did you try bleeding the system? Is the fuel cut solenoid wire connected and do you have battery voltage at it while cranking? Are glow plugs working?

SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Thursday, October 25th, 2012 AT 4:14 PM

Please login or register to post a reply.

Similar Questions

2003 Toyota Prado 2 Cylinders Not Firing

Engine Performance Problem 2003 Toyota Prado 4 Cyl Four Wheel Drive Manual I Have A Toyota Prado Equiped With 3rz Fe Engine And Is ...
Asked by lfxlal ·
1 ANSWER

2004 Toyota Prado Engine Wont Start

Electrical Problem 2004 Toyota Prado 4 Cyl Four Wheel Drive Manual Engine Crank Over Normally But Wont Start And I Observed That When ...
Asked by kamaraSA ·
1 ANSWER

Engine Doesn't Start Work In The Morning

1 In The Cooling Day The Engin Doesn't Work 2 If It Is Work There Is Excessive White Smoke And After That Start Black Smoke ...
Asked by Talib Al-saadi ·
5 ANSWERS

Starting Problem

I Scan The Car With The X431 Launch. The Code Is P0340. Means The Crank Shaft Position Sencer Circuit (g Signel)i Check All The Wires Also ...
Asked by shahid ishaq ·
1 ANSWER