SPONSORED LINKS

1998 DODGE RAM IMMEDIATE SHUT OFF

  • Tiny
  • William96
  • 1998 Dodge Ram
  • 109,117 miles

Ive rebuilt the engine in my dodge ram 1500 5.9l about a year ago and replaced the crankshaft positioning sensor in it and just recently replaced the fuel pump distributor and ignition coil but the truck will run until it gets to temperature around 180 degrees and then shut off and wont start till its cool again it has fuel pressure when it shuts off and I checked for spark after it stalled and theres nothing

SPONSORED LINKS
Do you
have the same problem?
Yes
No
Saturday, October 5th, 2013 AT 9:22 PM

4 Replies

  • Tiny
  • saturntech9
  • Expert
  • 29,879 posts

When you don't have spark have you checked for power And a flashing ground to the coil?

Was this
answer
helpful?
Yes
No
Saturday, October 5th, 2013 AT 9:39 PM
  • Tiny
  • William96
  • Member

Checked for power to the distributor and I dont know what you mean by flashing ground to coil

SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Saturday, October 5th, 2013 AT 10:12 PM
  • Tiny
  • rasmataz
  • Member

It probably meant -ground the coil wire and crank engine over and see if it sparks-

Was this
answer
helpful?
Yes
No
Saturday, October 5th, 2013 AT 11:54 PM
  • Tiny
  • saturntech9
  • Expert
  • 29,879 posts

No I ment a pulsing/flashing ground while cranking the engine to the coil. Also power to the coil not distributor.

Was this
answer
helpful?
Yes
No
Sunday, October 6th, 2013 AT 8:07 AM

Please login or register to post a reply.

Similar Questions

1996 Dodge Ram Crank Sensor

Electrical Problem 1996 Dodge Ram V8 Four Wheel Drive Automatic 122222 Miles How Do I Go About Replacing The Crank Sensor Thanks, ...
Asked by hogbgone ·
4 ANSWERS

Wont Move

The Truck Will Start And Idle But Is Not Getting Any Power When Accelerating It Wont Go Forward Or Reverse Just Sits There I Have Changed ...
Asked by mikecraig ·
3 ANSWERS

2003 Dodge Ram Crank Sensor

Electrical Problem 2003 Dodge Ram 6 Cyl Four Wheel Drive Automatic Can The Crank Sensor Burning Out Burn Out The Skim Module For The ...
Asked by volks willy ·
1 ANSWER

Engine Code Said Bad Crankshaft Sensor. Replaced With ...

Engine Code Said Bad Crankshaft Sensor. Replaced With New Sensor, Engine Runs Worse Than Before And Sounds Like Its Out Of Time. Any Ideas
Asked by Anonymous ·
1 ANSWER