Transmission suddenly started slipping only sometimes an only when hot. Could it be a sensor?

SATURNTECH9

MECHANIC
30,870 POSTS

Was there a clip on the axle end?Also did you check to see if the fuse had power when the interior lights wereinop?

Was this

answer

helpful?

Yes

Friday, January 11th, 2013 AT 12:57 AM

DOUG_IRE

MEMBER
38 POSTS

There was no clip on the axle.

SPONSORED LINKS

Was this

answer

helpful?

Yes

Friday, January 11th, 2013 AT 4:42 AM

DOUG_IRE

MEMBER
38 POSTS

While changing the tie rod on the same side I noticed the axle wobbles ( a lot of movement) on the transmission end. Is this normal?

Was this

answer

helpful?

Yes

Saturday, January 12th, 2013 AT 2:14 AM

SATURNTECH9

MECHANIC
30,870 POSTS

Wobbles a lot like what?Up an down in and out?Also when does it wobble when the transmission is spinning it?

Was this

answer

helpful?

Yes

Monday, January 14th, 2013 AT 4:59 PM

DOUG_IRE

MEMBER
38 POSTS

Wobble is up and down/side to side I took a short movie, but tightened up when had weight on the tire

SPONSORED LINKS

Was this

answer

helpful?

Yes

Wednesday, January 16th, 2013 AT 8:54 PM

SATURNTECH9

MECHANIC
30,870 POSTS

Then your good there always more wobbly with the weight off the car.

Was this

answer

helpful?

Yes

Thursday, January 17th, 2013 AT 12:45 AM

JOHN SHAVER

MEMBER
1 POST
1998 CHEVROLET MALIBU
2.4L
4 CYL
2WD
AUTOMATIC
200,000 MILES

I had an Evap code, so I replaced the gas cap. Then what happened was I sprayed hose connections to hopefully find the leak, then it ran worse. Now, I have codes PO108 and PO300. Cleaned IAC unit and cleaned the carburetor, and then took it for a test drive. Now, it shifts very hard like in a jerky clunky fashion. It seems to have more power now, better takeoff. A small hose has a hissing sound coming from it now, did not before. It is the small hose that goes to the carburetor.

Was this

answer

helpful?

Yes

Monday, August 7th, 2017 AT 11:55 AM (Merged)