SPONSORED LINKS

No spark from engine?

Tiny
JHESPO
  • MEMBER
  • 1999 TOYOTA CAMRY
  • 86,000 MILES
I have already replaced the ignition coils on the car(2). I also replaced the crank position sensor, all of the fuses are good, the timing belt is good. But I am still not receiving a spark to the engine. My mechanic has given up and cannot figure out what is wrong with it, the only guess he has is that it could be an ecu problem.
SPONSORED LINKS
Saturday, April 27th, 2013 AT 5:12 PM

12 Replies

Tiny
ASEMASTER6371
  • MECHANIC
  • 52,797 POSTS
Does the timing belt turn??? This guide can help us fix it

https://www.2carpros.com/articles/how-to-test-an-ignition-system

Please run down this guide and report back.

Roy
Was this
answer
helpful?
Yes
No
Saturday, April 27th, 2013 AT 5:15 PM
Tiny
JHESPO
  • MEMBER
  • 2 POSTS
My mechanic said the timing belt is fine
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Saturday, April 27th, 2013 AT 6:58 PM
Tiny
ASEMASTER6371
  • MECHANIC
  • 52,797 POSTS
Assuming it is a v6 as you stated no motor. I would start with checking for power to the coils with key on engine off.

You may want to consider a new shop as it is a basic issue that anyone should be able to figure out with proper test equipment

Roy
Was this
answer
helpful?
Yes
No
Sunday, April 28th, 2013 AT 6:53 AM
Tiny
ONCEKNOWN
  • MEMBER
  • 2 POSTS
  • 1998 TOYOTA CAMRY
  • 170,000 MILES
I have a 1998 Toyota Camry v6 LE, and recently my car will not start. There is no spark from the engine from turning the key, and lately I have been noticing that the light of the time for my dashboard has been getting dim lately, especially when I turn on my ignition key.

My dad has tried to boost start with his car. But it still won't turn on. Lately, I have been noticing that it would take just a few secs more to start up. Takes a bit longer to accelerate? But it's a pretty old car.
Was this
answer
helpful?
Yes
No
Sunday, August 2nd, 2020 AT 11:17 AM (Merged)
Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Check the fuel pressure if its correct, injector/s pulsing and ignition spark-if all okay check engine compression
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Sunday, August 2nd, 2020 AT 11:17 AM (Merged)
Tiny
MHPAUTOS
  • MECHANIC
  • 31,938 POSTS
Have you scanned for fault codes as yet?
Was this
answer
helpful?
Yes
No
Sunday, August 2nd, 2020 AT 11:17 AM (Merged)
Tiny
ONCEKNOWN
  • MEMBER
  • 2 POSTS
Thank you for your guys help. I found out that the battery was dead and had to go buy a new one. Thank you once again!
Was this
answer
helpful?
Yes
No
-1
Sunday, August 2nd, 2020 AT 11:17 AM (Merged)
Tiny
KOWA
  • MEMBER
  • 2 POSTS
  • 1997 TOYOTA CAMRY
  • 253,000 MILES
Weve got no spark on our 2L camry, we replaced the coil with a 180i corrola's. We took out a plug wire and inserted a plug and hold it agaist the engine. We switch on the car hte feul pomp comes on and tested the distributor by turning it outside the car and got spark. But when we insert the distributor and put everything in place and start turning the key the fire are gone. As soon as we took out the distributor and test it outside we got spark again. Bot dont work when its fitted.
Was this
answer
helpful?
Yes
No
Sunday, August 2nd, 2020 AT 11:17 AM (Merged)
Tiny
KHLOW2008
  • MECHANIC
  • 41,815 POSTS
Insert the distributor without the cap crank the engine and check if the rotor is turning. If it does not turn, you have a filed timing belt.

This guide can help us fix it

https://www.2carpros.com/articles/how-to-test-an-ignition-system

Please run down this guide and report back.
Was this
answer
helpful?
Yes
No
Sunday, August 2nd, 2020 AT 11:17 AM (Merged)
Tiny
KOWA
  • MEMBER
  • 2 POSTS
We have check the timing and timing belt everything are correct.
Was this
answer
helpful?
Yes
No
Sunday, August 2nd, 2020 AT 11:17 AM (Merged)
Tiny
KHLOW2008
  • MECHANIC
  • 41,815 POSTS
At the distributor, ensure you have battery voltage at the main supply wire with ignition switch turned on and also WHILE cranking. A faulty ignition switch would cut off the power supply.
Was this
answer
helpful?
Yes
No
Sunday, August 2nd, 2020 AT 11:17 AM (Merged)
Tiny
DJCL
  • MECHANIC
  • 767 POSTS
Make shore the rotor is spinning. Verify the cam shaft is not broken.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Sunday, August 2nd, 2020 AT 11:17 AM (Merged)

Please login or register to post a reply.

Related No Spark Content

Ignition Spark Check
GUIDE
Ignition Spark Check
An engine's ignition system is responsible for igniting the fuel-air mixture inside the combustion chamber and when the ignition process stops the engine will not run....
VIEW MORE

Sponsored links