BECOME A MEMBER
Sign up with Facebook
I agree to the
Login with Facebook
NOT A MEMBER?
Master Primary Cylinder
How do I get the clutch rod out of the old.
1997 DODGE DAKOTA
How do I get the clutch rod out of the old master cylinder to get the system out of the truck
Saturday, January 26th, 2013 AT 9:45 PM
It is held on to the clutch pedal with a pin that has a clip on the end to hold it to the rod.
Saturday, January 26th, 2013 AT 11:27 PM
to post a reply.
Related Transmission Clutch Master Primary Cylinder Content
How Do You Bleed The Clutch System On A 1997 Dodge...
I Completely Replaced My Entire Clutch System Everything But The Pedal. The Slave Cylinder Broke During Installation Of A New Clutch And Now...
1988 Dakota 4x4 Changing Clutch?
I'm Changing A Clutch In A 1988 Dodge Dakota 4x4, And I'm Stuck. I Removed Both Driveshafts, All The Bolts Out Of The Bellhousing, Took...
2001 Dodge Dakota Replace Clutch
Engine Performance Problem 2001 Dodge Dakota 4 Cyl Two Wheel Drive Manual 102000 Miles How?
1998 Dodge Dakota Truck Wont Run
For Starters, The Truck Won't Hardly Start Until You Work The Clutch Pedal. When You Get The Pedal Held Just Right It Will Start. It Was...
1999 Dodge Dakota Clutch
Replaced Clutch Pressure Plate Throw Out Bearing Slave And Clutch Master Clutch Works Good For About 2 Miles Then Can't Get In Gear Shut...
Anthony ramey 1
Ask a Car Question. It's Free!
Check Engine Light Clear
Code Read Retrieval/Clear
Find a car manual for your car
© 1999 - 2018 2CarPros, Inc.