1997 Buick lasbre limted

Tiny
ROLAND N
  • MEMBER
  • 1997 BUICK LESABRE
  • 6 CYL
  • FWD
  • AUTOMATIC
  • 179,000 MILES
Where is the blower motor resister located?
Do you
have the same problem?
Yes
No
Sunday, February 13th, 2011 AT 10:57 PM

1 Reply

Tiny
SATURNTECH9
  • EXPERT
Remove or Disconnect

1. Negative battery cable.
2. Rear engine sight shield.
3. Center bolt and positive booster cable from multi-use relay and fuse bracket.
4. Underhood fuse blocks and relays from bracket and position aside.
5. Nuts attaching multi-use relay and fuse bracket to front of dash, and bracket from vehicle.
6. CPA and connector from blower resistor assembly.
7. Screws attaching blower resistor assembly to heater and A/C module assembly.
8. Blower resistor assembly from vehicle.

Install or Connect

1. Screws attaching blower resistor assembly to heater and A/C module assembly after positioning in vehicle.

Tighten

* Screws to 1.4 N.M (12 lb. In.).

2. Connector to blower resistor assembly and CAP.
3. Nuts attaching multi-use relay and fuse bracket to front of dash after positioning on vehicle.

Tighten

* Nuts to 3.8 N.M (34 lb. In.).

4. Position fuse blocks and relays to bracket and snap m.
5. Center bolt attaching positive booster cable to multi-use relay and fuse bracket after positioning cable.

Tighten

* Bolt to 10 N.M (89 lb. In.).

6. Rear engine sight shield.
7. Negative battery cable.

Tighten

* Negative battery cable to 15 N.M (11 lb. Ft.).
Was this
answer
helpful?
Yes
No
Sunday, February 13th, 2011 AT 11:54 PM

Please login or register to post a reply.

Recommended Guides