It has the 24 valve v-6 dual over head cam engine.
October, 10, 2012 AT 1:33 PM
Have you checked for trouble codes?
The crankshaft position sensor is at lower right side of engine and if installing the belt causes it to fail to start, there is a possibility the sensor or its wiring is being affected by the belt. Inspect closely and ensure the sensor or wire is not too close to the belt. Try wiggling the wires if necessary and check for abrasion damages.
Check for sparks while cranking. If no sparks are available, it means the crankshaft position sensor is not working correctly.
October, 11, 2012 AT 1:14 PM
Ok thanks I will try that then I will let you know the outcome. Thanks for helping me thry and figure this out.