INERTIA SWITCH WIRING DIAGRAM

  • Tiny
  • RSM61
  • 1995 FORD RANGER
  • 200,000 MILES

I need a diagram for the inertia switch. It is a 3 wire switch

Do you
have the same problem?
Yes
No
Friday, May 18th, 2012 AT 1:48 AM

7 Replies

  • Tiny
  • ASEMaster6371
  • EXPERT
  • 25,554 POSTS

Are you sure you have the right switch? It is a 2 wire switch.

One wire from the relay and the other goes to the pump.

Roy

Was this
answer
helpful?
Yes
No
Friday, May 18th, 2012 AT 1:55 AM
  • Tiny
  • RSM61
  • MEMBER

I just removed it. It's a 3 wire

Was this
answer
helpful?
Yes
No
Friday, May 18th, 2012 AT 1:57 AM
  • Tiny
  • RSM61
  • MEMBER

The truck is an extended cab with the 3.0 and automatic

Was this
answer
helpful?
Yes
No
Friday, May 18th, 2012 AT 2:00 AM
  • Tiny
  • ASEMaster6371
  • EXPERT
  • 25,554 POSTS

Did you remove it from the right side under the dash by the trans hump?

Roy

Was this
answer
helpful?
Yes
No
Friday, May 18th, 2012 AT 2:02 AM
  • Tiny
  • RSM61
  • MEMBER

It was on the right side next to the kick panel. It's the inertia switch. I dealt with this on a 1998 B2500 I had.

Was this
answer
helpful?
Yes
No
Friday, May 18th, 2012 AT 2:04 AM
  • Tiny
  • RSM61
  • MEMBER

I figured out what I needed. The switch is marked NO C NC so that told me which 2 wires I needed to put a jumper wire on. Thanks.

Was this
answer
helpful?
Yes
No
Friday, May 18th, 2012 AT 2:20 AM
  • Tiny
  • Benbro
  • MEMBER

RSM61. Please explain the last post for a newby. NO C NC ? Could you share a diagram of which pins this refers to and what the letters mean?

I also need to know which pins to jumper. Sorry, but your last message was unclear to me.

Thank you, I appreciate your help.

Ben

Was this
answer
helpful?
Yes
No
Sunday, September 15th, 2013 AT 7:09 AM

Please login or register to post a reply.

Other Inertia Switch Questions