BECOME A MEMBER
Sign up with Facebook
I agree to the
Login with Facebook
NOT A MEMBER?
I tried to replace a ignition switch and it was in the lock position
1995 FORD F-150
I had to drill the switch out and I drill to far with the drill what can I do it damaged the area in the back where the switch goes and the switch won't go all the way in.
have the same problem?
Monday, February 13th, 2012 AT 10:44 PM
Yes, this is unfortunate but it does happen, you will need a used column or a column repair piece from the dealer.
Monday, February 13th, 2012 AT 11:01 PM
to post a reply.
Related Switche Ignition Switch Replace/Remove Questions
1995 Ford F150 Changing An Ignition Switch
Electrical Problem 1995 Ford F150 V8 Four Wheel Drive Automatic 152000 Miles I Have A 1995 Ford F 150 And I Need To Change The Ignition...
Ignition Switch Removal
Ignition Does Not Lock Steering Wheel, And Stays On With Key Removed, Dis Charging Battery. I Do Not Know How To Remove Ignition So That I...
1983 F-150 Starter Stays Engaged When Bump Starting...
1983 F 150 Starter Stays Engaged When Bump Starting Soliniod Replaced Ignition Switch & Key Lock Cylinder
1988 Ford F150 Ignition Switch Replacement
Steering Problem 1988 Ford F150 6 Cyl Two Wheel Drive Manual 150000 Miles How Do I Install The New Ignition Switch Properly I Am...
Ask a Car Question. It's Free!
Replace Ignition Switch
Ignition Switch Stuck
Battery Replacement Guide
Find a car manual for your car
© 1999 - 2017 2CarPros, Inc.