I REPLACED THE STOP LIGHT SWITCH TODAY AND I ...

1994 Ford Ranger

Tiny

brianpatrick

January, 17, 2013 AT 2:39 AM

I replaced the stop light switch today and I just checked to see if they were still working and nothing. Its a brand new switch and when I push the whole unit up the brakes come on but I cant figure out whats going on with it

FOUND 484 RELATED QUESTIONS

2 Answers

Tiny

ASEMaster6371

January, 17, 2013 AT 2:49 AM

Did you put the bushings back on? There are 2 bushings for the switch that must be there

Roy

Tiny

brianpatrick

January, 17, 2013 AT 7:02 PM

I put a test light on it and i'm not getting any power through the constant hot wire lite green with red tracer. It only had one bushing on it and I made sure it was there. I'm out of ideas. Checked all wires and Hazards work, turn signals work, reverse and license plate lights all work too. I even tried a jumper wire to complete the circuit and still nothing. No blown fuses and all bulbs work with headlights on

Please login or register to post a reply.

Brake Pad & Rotor Replacement Acura TL
Read Codes Like a Pro
Engine Oil Change and Filter Mercedes
Engine Oil Change and Filter Jeep Wrangler
Serpentine Belt Replacement Ford Contour