BECOME A MEMBER
Sign up with Facebook
I agree to the
Login with Facebook
NOT A MEMBER?
Rear Crankshaft Seal
Truck wont drive after replacing rear main seal?
1993 CHEVROLET CHEYENNE
When I put the truck in drive it wont move unless I Floor it. When I floor it only moves foward a little and very slow.
have the same problem?
Monday, October 3rd, 2011 AT 12:09 AM
Did you refill the transmission? Attach the flexplate to torque converter bolts?
Monday, October 3rd, 2011 AT 12:20 AM
to post a reply.
Related Crankshaft Rear Crankshaft Seal Replace/Remove Content
1996 Chevy Cheyenne Crank Sensor
My Truck Doesnt Start Some Time If It Start, Start With Ignition Engine Runs Very Smooth. The Mechanic Checked The Elecrical System No...
Crankshaft Seal Replacement - Rear
Your car's engine rear main crankshaft seal is designed to give the engine oil leak protection from between the crankshaft output flange and the engine block. This seal is...
1996 Chevy Cheyenne Codes
Engine Mechanical Problem 1996 Chevy Cheyenne V8 Two Wheel Drive Manual My Truck Has Miss. I Put It On A Computer. It Say There Is A...
1993 Chevy Cheyenne Possible Oil Pressure Switch...
Engine Starts And Runs A Few Seconds And Dies. I Started It And Gunned It And It Ran As Long As I Gunned, Then Drove A Bit. Killed It And...
1993 Chevy Full Size
I Have Been Adjusting The Idle On My Truck And Ever Since I Started Doing This You Can Smell Gas For About The First 5 To 10 Minutes After...
Cold Air Intake And Mass Airflow Sensor
I'm Interested In Buying A Cold Air Intake For My 4.3l V6 C1500. Will I Have To Buy A New Mass Airflow Sensor Or Will The Stock One Work?
Ask a Car Question. It's Free!
Crankshaft Main Seal Replacement - Front
Find a car manual for your car
Terms & Conditions
© 1999 - 2018 2CarPros, Inc.