Hazards lights not working

Tiny
SID LANSDELL
  • MEMBER
  • 1993 DODGE DAKOTA
  • 3.9L
  • V6
  • 2WD
  • AUTOMATIC
  • 129,000 MILES
Checked all fuses, replaced headlamp, ignition and turn signal switch, replaced brake light switch and checked grounds.
Wednesday, March 20th, 2019 AT 2:29 PM

14 Replies

Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 108,170 POSTS
Welcome to 2CarPros.

On this vehicle, there are two flashers. One is for the signals and the other the hazard flashers. Both flashers are located under the dash on the driver's side in the fuse/relay panel. Have you tried replacing it? See the attached wiring schematic.

Let me know if that helps.

Joe
Was this
answer
helpful?
Yes
No
-1
Wednesday, March 20th, 2019 AT 7:16 PM
Tiny
SID LANSDELL
  • MEMBER
  • 1 POST
No power at flasher. The blinkers and everything else is working properly. Help
Was this
answer
helpful?
Yes
No
-1
Thursday, March 21st, 2019 AT 6:47 PM
Tiny
DUKENUKEM102
  • MEMBER
  • 2 POSTS
  • 1992 DODGE DAKOTA
  • V8
  • 4WD
  • AUTOMATIC
  • 203,000 MILES
I have a 1992 dodge Dakota. The headlights brake lights and the hazard lights do not work, although both front and back turn signals work. How do I check or replace the wiring? I am also looking for the cheapest and quickest route to do this. Should I do this myself or take it to a auto body shop or the dodge dealership?
Was this
answer
helpful?
Yes
No
-2
Thursday, March 21st, 2019 AT 6:48 PM (Merged)
Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
Check fuse G inpower dist center underhood first. If it blows again tehn you'll hav eot check for a short on wiring or switch
Was this
answer
helpful?
Yes
No
-2
Thursday, March 21st, 2019 AT 6:48 PM (Merged)
Tiny
DUKENUKEM102
  • MEMBER
  • 2 POSTS
Ive checked the fuse and its not blown how do I go about checking for a short
Was this
answer
helpful?
Yes
No
-1
Thursday, March 21st, 2019 AT 6:48 PM (Merged)
Tiny
HMAC300
  • MECHANIC
  • 48,601 POSTS
It's a good chance your switch is bad then, see if the switch gets power and if it does then see if when you turn it on it sends power out. If it does then you need to check those wires. Also check to see if headlight is burnt out it will get power. Oneother thing if this has a floor dimmer switch disconnect it and see if the headlights work they get corroded and will on ly let like high beams work.
Was this
answer
helpful?
Yes
No
+2
Thursday, March 21st, 2019 AT 6:48 PM (Merged)
Tiny
GREGTS
  • MEMBER
  • 2 POSTS
  • 1999 DODGE DAKOTA
Electrical problem
1999 Dodge Dakota 6 cyl Two Wheel Drive Automatic

signals work sometime and sometime not
Was this
answer
helpful?
Yes
No
Thursday, March 21st, 2019 AT 6:48 PM (Merged)
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 108,170 POSTS
When they don't work, does nothing happen, does the indicator light up and not flash, or do they flash really fast?
Was this
answer
helpful?
Yes
No
-1
Thursday, March 21st, 2019 AT 6:48 PM (Merged)
Tiny
GREGTS
  • MEMBER
  • 2 POSTS
May blink once or twice or not at all
Was this
answer
helpful?
Yes
No
+2
Thursday, March 21st, 2019 AT 6:48 PM (Merged)
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 108,170 POSTS
IT sounds like either the flasher is bad, or the switch itself. For it not to flash as all, power is stopped at some point. When this happens, you need to check to see if there is power to the flasher (under dash / or could be in the power distribution box under the hood). If there is power, switch out the flasher. If there is no power, you will need to get into the steering column to check for power in and out of the signal switch.
Was this
answer
helpful?
Yes
No
+1
Thursday, March 21st, 2019 AT 6:48 PM (Merged)
Tiny
GREGTS
  • MEMBER
  • 2 POSTS
No power at hazard flasher power to turn signal switch from headlight switch but not out. New turn signal has been installed. My brake pedal switch relay has six wires on it. Where do they go to? The hazard flasher is separate from turn signal flasher. Please help
Was this
answer
helpful?
Yes
No
Thursday, March 21st, 2019 AT 7:13 PM
Tiny
GREGTS
  • MEMBER
  • 2 POSTS
Hazard sw is built into turn signal sw. And has separate fuse, fuse has power but to to hazard sw has power from headlight to turn signals they all work but no hazards lights
Was this
answer
helpful?
Yes
No
Sunday, March 24th, 2019 AT 10:22 AM
Tiny
GREGTS
  • MEMBER
  • 2 POSTS
I've checked all you mentioned no results, please help
Was this
answer
helpful?
Yes
No
-1
Monday, March 25th, 2019 AT 11:45 AM

Please login or register to post a reply.

Sponsored links