I JUST REPLACED MASTER AND SLAVE CYLINDER ON MY ...

1991 Mitsubishi Galant

Tiny

Anonymous

November, 12, 2012 AT 6:19 PM

I just replaced master and slave cylinder on my car. I bleed the hydrolic system and the slave cylinder extends fully when I push in the clutch. The transmission only goes into gear when the engine is not running. When the engine is off I can cycle though all the gears on the tranny. When I try to start the car in gear the car moves forward. Any suggestions?

FOUND 50466 RELATED QUESTIONS

1 Answer

Tiny

KHLow2008

November, 12, 2012 AT 6:56 PM

The clutch seems to be faulty and the problem is most likely to be the pressure plate.

Please login or register to post a reply.

Crank Angle Sensor Replacement Mercedes Benz
Crankshaft Position Sensor Replace Chevrolet