BECOME A MEMBER
Sign up with Facebook
I agree to the
Login with Facebook
NOT A MEMBER?
1990 Dodge 1/2 ton 4X4 1500 with a 318 motor
1990 DODGE TRUCK
1990 Dodge 1/2 ton 4x4 1500 with a 318 motor. Does this vehicle have a crank sensor?
Tuesday, December 18th, 2012 AT 8:22 PM
Yes on Trans bell housing
Tuesday, December 18th, 2012 AT 8:46 PM
to post a reply.
Related Crankshaft Crankshaft Sensor Content
2000 Dodge Truck Crankshaft Position Sensor
2000 Dodge 2500 Cummins. The Crankshaft Position Sensor Failed And Will Not Come Out Of The Block Any Suggestions On How To Get It Out
A crankshaft position sensor (CKS) is used to reference crankshaft rotation as the engine is running while supplying feedback data to the main computer. This sensor is...
I Put A New Clutch And Is Running Good But When The...
I Put A New Clutch And Is Running Good But When The Truck Is Running At Idle Run For A Few Minutes And Then Stops I Check The Fuel Pump An...
2000 Dodge Truck Oil Fill Cap
How Do I Remove The Oil Fill Cap To Add Oil To My Truck? Can Not Get It Off By Screwing It Like My Chevy Truck :( Thanks In Advance, Kat
2001 Dodge Truck No Oil Added Back In After Oil Change
I Went Yesterday To Have My Oil Changed And After I Left About 1 Mile Down The Road Truck Stalled And Made A Hard Clicking Noise And Drawing...
1999 Dodge Truck Engine Replacement
Hi Guys I Have Donated Twice And I Have One Last Question. Where Can I Find A Diy Dodge Engine Swap Book Or Info? I Have Replaced/rebuilt...
Ask a Car Question. It's Free!
Crankshaft Position Sensor Replace Chevrolet
Crank Angle Sensor Replacement Mercedes Benz
Crankshaft Sensor Replacement
Find a car manual for your car
Terms & Conditions
© 1999 - 2018 2CarPros, Inc.