My uncle replaced his clutch master cylinder.

Tiny
MUSICALIFORNIA88
  • 1990 CHEVROLET SILVERADO
  • 120,000 MILES

My uncle replaced his clutch master cylinder, topped off the dot 3 bled line but not much fluid bled through the line and as a result there is little to no pedal pressure any ideas?

Do you
have the same problem?
Yes
No
Saturday, November 17th, 2012 AT 10:59 PM

1 Reply

Tiny
MHPAUTOS
  • EXPERT
  • 30,949 POSTS

Keep bleeding, hold down pedal crack bleeder and close bleeder while you still have some fluid flowing, keep reservoir topped up, do not lift pedal until bleeder is firmly locked off, wait a few seconds and repeat, do this until no air is visible, it should bleed easily.

Please consider a donation to help us answer more questions.
Was this
answer
helpful?
Yes
No
Sunday, November 18th, 2012 AT 12:49 AM

Please login or register to post a reply.

Related Transmission Clutch Master Primary Cylinder Replace/Remove Questions

Help us by donating