BECOME A MEMBER
Sign up with Facebook
I agree to the
Login with Facebook
NOT A MEMBER?
Do I need the restrictor cap on the heater hose that comes off the intake manifold?
1989 CHEVROLET TRUCK
I just replaced the head gaskets, but the motor overheats. I have checked the thermostat and the water pump.
have the same problem?
Saturday, December 3rd, 2011 AT 5:52 PM
The head could be cracked-check the oil if its milky
Saturday, December 3rd, 2011 AT 6:13 PM
I had the heads sent to a machine shop. They were milled down and had new valve seals installed. They were also checked (magnafluxed)for cracks. Any other ideas.
Saturday, December 3rd, 2011 AT 6:29 PM
Try bleeding the cooling system
Saturday, December 3rd, 2011 AT 6:34 PM
to post a reply.
Related Heater Hose Replace/Remove Content
1993 Chevy Truck Heater Hose Inlet Quick Connect...
Where The Heater Hose Inlet Tube Connects To The Engine Intake Is A Quick Connector. Do I Have To Have A Special Tool To Remove This Metal...
1996 Chevy Truck Heater Hose Fitting On Intake
I Replaced The Fitting And When I Did That The Threaded Hole Cracked. I Now Have A Slow Leak. Is There Anything I Can Do To Fix This...
Heater Not Blowing Heat
Heater Problem V8 Four Wheel Drive Automatic I've Changed Out My Heater Core And Thermostat In The Truck, Fan Blows Hi But No Heat...
1989 Chevrolet Truck K1500 Very Little Heat
I Just Did Thermostat And Heater Core And I Am Getting Luke Warm Heat What Could Be Going On Here? Blend Door Is Opening And Closing As It...
Ac And Heater Not Working
I Bought A New Control Panel Because We Thought That Was The Problem. Installed It And Nothing Works Or Makes Noises. The Two Wires Are...
Ask a Car Question. It's Free!
No Air Coming From Vents
Air Conditioner Vacuum and Recharge
Add Refrigerant (Freon)
Find a car manual for your car
© 1999 - 2018 2CarPros, Inc.