I am having fuel injector problems. I have replaced the distributor module, TPS, and the computer itself! Tested fuel pressure it primes to about 30 lbs and when I can start the motor it runs at about 36 lbs, when I crank the motor pressure stays about the same but wont start. So I hook my noid lights up and they aren't flashing when I crank but if I prime the intake and start the engine the noid will flash! Have checked all my grounds, check all my relays and fuses. I just am out of ideas and would very much appreciate any help or advice.
Saturday, December 8th, 2012 AT 8:13 PM