BECOME A MEMBER
Sign up with Facebook
I agree to the
Login with Facebook
NOT A MEMBER?
I have repalced the ignition coil the Pickup.
1988 CHEVROLET SUBURBAN
I have repalced the ignition coil the pickup coil and changed out ignition module but still nothing so put the old one back in still nothing coil is getting power but still isnt sparking why
Image (Click to enlarge)
Friday, January 18th, 2013 AT 4:00 AM
I would look at the cap and rotor. Check there first for burn marks.
If you pull off the coil wire, does it spark around the tower when cranking?
Friday, January 18th, 2013 AT 11:52 AM
to post a reply.
Related Ignition Module Replace/Remove Content
1999 Chevy Suburban Heat Causes Surburban To Die
When The Temp Is 80 Or Higher Outside, While Driving Engine Dies. While In Process Of Dying If I Push The Gas Too Hard It Just Dies Out...
Replace Ignition Control Module
Instructional repair video
My 1996 Chevy Surburban 1500 5.7l 2wd Will Turn Over...
My 1996 Chevy Surburban 1500 5.7l 2wd Will Turn Over Ok When Trying To First Start, But Will Not Completely Engage The Full Start. But...
1996 Chevy Suburban Ignition Control Modul
Electrical Problem 1996 Chevy Suburban V8 Four Wheel Drive Automatic Where Is The Ignition Control Module Located
Hello, I Bought A 1994 Chevy Suburban K1500 With 5.7tbi. It Has No Spark, It Has Compression And Fuel, But No Spark. Can Someone Help Me...
No Fuel Between Schrader Valve And Spark Plug
Suv Will Not Start. I Have Sixty Two Pounds Pressure At Schrader Valve. Fire At The Spark Plug. Sprayed Starter Fluid Down Throttle Body...
Ask a Car Question. It's Free!
How to fix an engine not starting
Engine Will Not Start
How to Use a Test Light
Find a car manual for your car
Terms & Conditions
© 1999 - 2018 2CarPros, Inc.