BECOME A MEMBER
Sign up with Facebook
I agree to the
Login with Facebook
NOT A MEMBER?
Have put on 4 brand new Master cylinders all.
1981 FORD 500
Have put on 4 brand new master cylinders all leak in the back of the master cylinder. Could a bent push rod in the brake booster be the problem. Or what could be the problem
Sunday, December 16th, 2012 AT 3:41 PM
Whats the odds of 4 bad ones? I in a million.
The booster is your failure as it is sucking the fluid out of the master when running.
Sunday, December 16th, 2012 AT 3:42 PM
to post a reply.
Related Camshaft Pushrod Content
How Do You Know If The Cam Sensor Is Going Bad?
Changing Engine Size
Will A Ford 382 Engine Bolt Up To My F-250 Ford Ranger
Where Is The Iat Sensor On A 1993 F-150 5.0 Four Wheel Drive? I Keep Getting Told That Is On The Drivers Side Of The Intake Manifold, But...
Occasional Non Starter
1998 Ford Taurus, 3.0 Dohv : Did Not Start, Turned Over, But The Next Morning Started Right Up. It Ran Fine For One Week Then The Same...
Passenger Rear Brake Piston
Okay, I Have The Special Tool, I Have Been Pressing Down As Hard As I Can (to The Point My Hand Hurts Even With Heavy Gloves) And Turning...
Ask a Car Question. It's Free!
Camshaft Sensor Replacement
How to Tell Which Cylinder is Misfiring!
Find a car manual for your car
Terms & Conditions
© 1999 - 2018 2CarPros, Inc.