I replaced the clutch in my Chevy k20 but my throw out bearing doesn't fit the input shaft of my trans all of the other parts in the kit are fine. What is the fix?
there was a speedy sleeve on the input shaft when I tore it down do I just replace the sleeve or do I need to get a different bearing?
SPONSORED LINKS
Do you
have the same problem?
Yes
No
Tuesday, May 15th, 2012 AT 4:02 AM
3 Replies
RASMATAZ
MEMBER
You gonna have to get a different throwout bearing
Was this
answer
helpful?
Yes
No
Tuesday, May 15th, 2012 AT 5:24 AM
CHRIS ROBINANDPOOH
MEMBER
Is this common enough that I can probably go to a tranny shop and get what I need without much problem?