BECOME A MEMBER
Sign up with Facebook
I agree to the
Login with Facebook
NOT A MEMBER?
1969 Ford Contour overheated. Replaced head and gasket and still won't start
1969 FORD CONTOUR
All the things I can check
have the same problem?
Tuesday, April 24th, 2012 AT 11:31 AM
Do or have a compression test done. You can also check cranking vacuum with a vacuum gage
Tuesday, April 24th, 2012 AT 11:46 AM
to post a reply.
Related Cylinder Head Gasket Replace/Remove Content
One Mechanic Said I Needed To Replace The Head Gasket...
One Mechanic Said I Needed To Replace The Head Gasket. I Was Told By Another That The Head Has A Crack In It. If It Is Second, How Much...
2000 Ford Contour Head Gasket
I Am Attempting To Replace A Head Gasket. So Far I Have The Valve Cover Off, Timing Belt Removed And One Camshaft Out. The Other Camshaft...
96 Ford Contour
My 1996 Ford Contour Wont Idle On Its Own. The Problem Started After It Over Heated And Then The Head Gasket Was Replaced. All The...
1995 Ford Contour Blown Head Gasket!!!
I Have Most Of The Parts Off Except 2 Bolts In The Center Of The Head I Guess That Are Stripped. How Much Do You Think It Would Cost Me For...
1999 Ford Contour Engine Cooling Issue
I Own A 1999 Ford Contour Se I Recently Had A Blown Head Gasket Replaced Head Gasket Timing Belt Water Pump Thermostat Housing Thermostat...
Ask a Car Question. It's Free!
Coolant Mixing with Oil
Engine Oil Change and Filter Mercedes ML350
TPS Sensor Step by Step Replacement Guide
Find a car manual for your car
© 1999 - 2018 2CarPros, Inc.